3/10/2020 Whirlpool Adp 130 Ix
WHIRLPOOL ADP130IX (ADP 130 IX), fiche technique, prix et avis Archives WHIRLPOOL ADP130IX. Lave-vaisselle WHIRLPOOL ADP130IX (ADP 130 IX) WHIRLPOOL ADP130IX Photos non contractuelles NOTE SUR 10 Notre site 3. Inconnu LIRE LES AVIS. WHIRLPOOL ADP130IX (ADP 130 IX), fiche technique, prix et avis Archives WHIRLPOOL ADP130IX. Lave-vaisselle WHIRLPOOL ADP130IX (ADP 130 IX) WHIRLPOOL ADP130IX Photos non contractuelles NOTE SUR 10 Notre site 3. Inconnu LIRE LES AVIS.
-1-
PROGRAM SELECTION
Push “Programs” button
of the required program lights
below).
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
washing cycle, the cycle is temporarely paused: the
Start indicator blinking. To restart the cycle close
CANCEL/OFF BUTTON
If pressed when a program is running it cancels the
If pressed when the dishwasher is switched off it
minute process).
If the indicator flashes repeatedly, see page 6 -
(see at right for options description)
1)Program data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programs as a result of the appliance’s automatic calibration system.
2)Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
Table of programs
gent
P
Available
Loading instructions
Minutes
1
DelayCrockery to be washed later.--5.00.0210
Glasses40°C
Light soiling, for example glasses
X13.00.9097
Quickwash40°C
Lightly soiled crockery, with no
X13.00.7030
Eco
50°C
Half load
5
Delay
heavily soiled crockery, especially
X15.01.50140
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED.
When lit (at the end of the
needs to be refilled.
Half load cycle can be used
Select the required program
button - the light comes on.
program. The “Half Load”
programs indicated in the
TABLET SETTING
This setting allows to optimize the cycle performances
Push the Tablet button for 3 seconds (until the indicator
lights up) if you are using the combined detergents in
tablet (rinse aid, salt and deteregent in 1 dose).
If you are using powder detergent or liquid detergent,
the Tablet indicator on the control panel has to be off.
BUTTON
programmed to start
Then press the Start
program will start after
RINSE AID INDICATOR
cycle), the rinse aid
refilled.
Options and display description
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |